The next three entries are partitions on the first array. You can only mount individual partitions. ![]() The top two entries are the stripe arrays (so far as I can figure out). This will give you output similar to the following.Īs I have two raid 0 arrays, one with three partitions and one with 1 partiton I get 6 entries in the list. If nothing happened in the previous step enter the command again. One with three partitions and one with one partition. Anything else and you should stop and reconsider going any further. ![]() This is normal and nothing to worry about. RAID set "nvidia_caacdjfa1" already active RAID set "nvidia_ehiaffhc3" already active RAID set "nvidia_ehiaffhc2" already active RAID set "nvidia_ehiaffhc1" already active RAID set "nvidia_caacdjfa" already active RAID set "nvidia_ehiaffhc" already active If the arrays are already active you'll get output something like this. In the terminal window enter the following command. NTFS Configuration Tool is now installed.Ĭreate A Mount Point For Your NTFS Partition.Įnter your root password if/when prompted. Select this for installation and click "Apply".Ĭlose when finished. ![]() There should only be one result called "NTFS Configuration Tool". dmraid is now installed.ĭo a search for "NTFS Configuration Tool". Select dmraid for installation and click "Apply".Ĭlose Synaptic when finished. System > Administration > Synaptic Package Manager.ĭo a search for "dmraid". Gives you the NTFS-3g driver needed for full read/write access to NTFS partitions. The Linux tool for accessing fakeRaid arrays like nividia stripe. You follow this tutorial at your own discretion.ĭmraid. If you kill or damage your PC you are to blame. Disclaimer: These are the commands I used.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |